Samsung Refrigerator User Manual page 19

1. Connect the household water line to the
assembled compression fi tting.
- If you are using copper tubing, slip the
compression nut ( B ) (not supplied) and
ferrule (not supplied) on the copper tubing (not
supplied) as shown.
- If you are using plastic tubing ( B ), insert the
molded end (Bulb) of the plastic tubing ( B ) into
the compression fi tting.
• Do not use without the molded end (Bulb)
of the plastic tubing ( B ).
CAUTION
2. Tighten the compression nut ( B ) onto the
compression fi tting.
Do not over-tighten the compression nut ( B ) .
3. Turn the water on and check for any leakage.
If you fi nd water drops or leakage in the
connection areas, turn off the main water
supply. Check the connections and, if
necessary, tighten.
4. Flush 1 gallon of water through the fi lter before
drinking or using the water from the refrigerator.
(Flush approximately 6 minutes.) To fl ush, press
a large glass or cup against the water dispenser
lever. Fill the glass, empty it into the kitchen sink
after it is fi lled, and then repeat.
5. After you turn on the refrigerator, let the ice
maker make ice for 1 to 2 days. Over that
period of time, throw out the fi rst 1 or 2 buckets
of ice the freezer makes to ensure all impurities
have been removed from the water line.
• Only connect the water line to a drinkable
water source.
If you have to repair or disassemble
the water line, cut off 1/4" of the plastic
tubing to make sure you get a snug,
leak-free connection.
• You can test the water line quickly using
a paper cup. Under normal conditions,
the water dispenser can fi ll a 5.75 oz.
(170 cc) cup in about 10 seconds.
DA68-03013A-03.indb 19 DA68-03013A-03.indb 19
English - 19
2014. 2. 25. 2014. 2. 25. 4:04 4:04