LG LED 500 Owner's Manual page 9

Keep the battery out of reach of chil-
y y
dren.
- This may result in personal injury or
damage to the product.
Make sure that the battery is installed
y y
correctly.
Incorrect battery replacement may
y y
cause fire.
Do not stare directly into lens when in
y y
operation, eye damage can occure.
No user serviceable parts inside unit.
y y
High voltage parts can cause shock
and even electrocution. Please see
owner's manual for service specifica-
tions.
Proper ventilation required, do not
y y
block airflow around unit. Doing so
can cause injury and internal over-
heating.
To prevent damage to lamp, unit
y y
must remain plugged in for approxi-
mately 3 minutes after power down
to allow for proper cool down (not
applicable on LED models).
Do not touch the lens; doing so can
y y
result in burns or damage to lens.
Lens and unit may be HOT during
and immediately after use. Use cau-
tion when handling unit, allowing for
proper cool down.
Only use a grounded electrical outlet.
y y
Do not insert anything into or cover
y y
up the exhaust vents.
Follow all maintenance guidelines for
y y
optimal use; service only at an autho-
rized service center.
Lamp contains mercury and as such
y y
must be disposed of according to
local, state and federal laws
(not applicable on LED models).
y y
SAFETY INSTRUCTIONS
CAUTION
Unplug the power cord if the projector
y y
is not used for a long period.
- Accumulated dust may cause
overheating, an electric shock from
corroded insulation and a fire from an
electrical surge.
Only use the specified type of battery.
y y
- Otherwise, this may cause an elec-
tric shock caused by overheating
and leakage.
Make sure you use the same type of
y y
battery when replacing.
(Battery CR2032/3V)
- In the case of a battery contact
failure, the battery may drain quickly
or the remote control may not work
properly.
9