Maintenance - VOLTA Mega Gen 3 U5010 Instruction Manual

MAINTENANCE

REMEMBER
1. If your cleaner does not operate check the
plug connections and the mains fuse.
If the cleaner still does not operate, please
consult the back cover of this booklet for our
customer service line.
2. Volta regret that they cannot regard the
clearing of a blocked hose being a service
provided free of charge, under warranty.
Changing the paper or cloth dust bag
Always operate the cleaner with paper or cloth
dust bag installed. If you forget to attach the dust
bag or attach it in the wrong manner, the dust cover
may not close properly.
1. After removing the hose, open
the front cover.
2. Raise the support of the bag to an
upright position.
3. Remove the dust bag.
4. In case of paper bag.
Replace the paper bag with new when it is full
or dust or dust bag indicator shows red.
In case of cloth bag
Follow the above 1,2,3 steps
To open, slide the plastic clip off the bag
Empty bag and refit the plastic clip
Note: The cloth bag may be washed in lukewarm water
and dried completely. It should not be washed
in washing machine.
5. Close the cover by pressing down
until it is locked
6. *Note: A cloth bag is not supplied with this
product. To purchase a cloth bag, please return
to the place of purchase or contact Electrolux
on 1300 365 305 (Aus), 0508 730 730 (NZ).
35127 ULTIMA & MEGA IFU_V5.indd 6
MAINTENANCE
WARNING:
On collection of proprietary carpet conditioning
powders, plaster / concrete dust, it is
recommended that the dust bag is changed.
Some of the preparations contain substances
which while left in the vacuum cleaner for
extended periods could create damage.
Many air fresheners, household deodorants,
sprays and polishes contain highly inflammable
gas propellants. Because of this it is particularly
important that these products are used strictly
in accordance with the relevant manufacturers
instructions. It is essential that none of the above
products are sprayed directly into the vacuum
cleaner or any of the filters, hose assembly or
dust chamber.
Cleaning motor filter
• Filter should be cleaned at least twice a year or
when it becomes visibly dirty.
• Always operate the cleaner with filter installed,
otherwise reduced suction or motor damage
may result.
• Disconnect from electrical outlet, before cleaning
the filter.
• Do not use a washing machine to rinse filter.
• Do not use hair dryer to dry it.
1. Pull dust bag by pulling dust bag collar
frame upwards.
2. Pull the filter holder upwards.
3. Remove filter from holder.
4. Rinse filter in lukewarm water and dry the
filter completely.
5. Put back filter into the filter holder and refit.
Changing the HEPA exhaust filter
1. Open the top hood of the vacuum cleaner.
2. Take the exhaust filter out and fit a new
clean filter.
3. Close the top hood.
5.
3/10/08 2:41:19 PM