Table of Contents
Advertisement
•
Tuner
TROUBLESHOOTING
Problem
Cause
Remedy
Refer
to page
FM stereo reception is
The characteristics of FM stereo
Check the antenna connections.
17
noisy.
broadcasts may cause this problem
Try using a high-quality directional FM
when the transmitter is too far away or
antenna.
the antenna input is poor.
Use the manual tuning method.
34
There is distortion, and
There is multi path interference.
Adjust the antenna position to eliminate
-
clear reception cannot
multipath interference.
be obtained even with a
FM
good FM antenna.
The desired station
The station is too weak.
Use a high-quality directional FM antenna.
17
cannot be tuned in with
. _ _1 . . _ . _
the automatic tuning
Use the manual tuning method.
34
method.
Previously preset
This unit has been disconnected for a
Re-store the stations.
35,36
stations can no longer
long period.
be tuned in.
The desired station
The signal is weak or the antenna
Tighten the AM loop antenna connections
17
cannot be tuned in with
connections are loose.
and orient it for best reception.
the automatic tuning
method.
Use the manual tuning method.
34
There are continuous
Noises result from lightning,
Use an outdoor antenna and a ground wire.
17
AM
crackling and hissing
tluorescent lamps. motors. thermostats
This will help somewhat, but it is difficult to
noises.
and other electrical equipment.
eliminate all noise.
There are buzzing and
A TV set is being used nearby.
Move this unit away from the TV.
-
Whining noises
(especially in the
evening).
•
Remote control
Problem
Cause
Remedy
Refer to
page
The remote control
Wrong distance or angle.
The remote control will function within a
7
does not work nor
maximum range of 6 m (20 feet) and no more
function properly.
than 30 degrees off-axis from the front panel.
Direct sunlight or lighting (from an
Reposition this unit.
-
inverter type of fluorescent lamp. etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
Replace all batteries with new ones.
3
The manufacture code has not correctly
Set the code correctly.
47
set.
Try setting another code of the same
-
manufacturer.
Even if the manufacturer code is
~
-
correctly set. there are some models that
do not respond to the remote control.
55
Advertisement
Table of Contents
