Platinum 7277094 Instruction Manual page 8

ENGLISH
10. After finishing making the coffee, you can take the metal funnel out through
turn clockwise, and then pour the coffee residue out with the steel mesh
pressed by press bar. Let them cool down completely, then rinse under
running water. (When assemble the steel mesh again, you shall turn over the
press bar to the original position)
B. FROTHING MILK/ MAKE CAPPUCCINO
You get a cup of cappuccino when you top up a cup of espresso with frothing
milk.
Method:
1. Prepare espresso first with container big enough according to the part "A.
MAKE ESPRESSO COFFEE".
2. Fill a jug with desired amount of milk for each cappuccino to be prepared, you
are recommended to use whole milk at refrigerator temperature (not hot!).
Note: In choosing the size of jug, it is recommend the diameter is not less
than 70±5mm, and bear in mind that the milk increases in volume, make sure
the height of jug is enough.
3. Turn the steam knob to the
4. Insert the frothing device into the milk about two centimetres, after about 2
minutes, the steam will come out from the frothing device. Froth milk in the
way moving vessel round from up to down.
5. When the required purpose is reached, you can turn the steam control knob
to position stop frothing. Then remove the jug and turn the steam
control knob to
Note: Clean steam outlet with wet sponge immediately after steam stops
generating, but care not to hurt!
6. Pour the frothed milk into the espresso prepared, now the cappuccino is
ready. Sweeten to taste and if desired, sprinkle the froth with a little cocoa
powder
Note: We recommend you allow the appliance to cool down before making
coffee again. Otherwise burnt odor may occur in your espresso coffee.
OFF
RELEASE
position release the residual steam in the tank.
position, the indicator will light up.
7