Panasonic WV-SW390 Series Operating Instructions Manual page 14

1 Monitor images on a PC
Control pad/buttons
•
(panning/tilting). Panning/tilting speed will be faster if a clicked point gets farther from the center point
of the control pad.
It is also possible to pan/tilt the camera by dragging the mouse.
Zoom and focus can be adjusted by right-clicking. When an upper/lower area of the control pad is
right-clicked, the displayed image will be zoomed in/out on. When a left/right area is right-clicked, the
focus will be adjusted to the Near/Far side.
Zoom can also be adjusted using the mouse wheel.
[Brightness] buttons
Available range: 0 - 255
•
button: The displayed image will be darker.
•
button: The adjusted brightness will return to the default brightness (64).
•
button: Image will be brighter.
[Preset]
*4
Select a preset position from the pull-down menu and click the [Go] button. The camera will move to the
selected preset position (®page 108). "H" next to the preset position number indicates the home position.
When "Home position" is selected, the camera will move to the home position. (®page 90) When "Preset
ID" is registered for a preset position, the registered preset ID will be displayed next to the preset position
number.
Camera title
The camera title entered for "Camera title" on the [Basic] tab will be displayed. (®page 49)
Alarm occurrence indication button
This button will be displayed and will blink when an alarm has occurred. When this button is clicked, the
alarm output terminal will be reset and this button will disappear. (®page 29)
Full screen button
Images will be displayed on a full screen. To return to the "Live" page, press the [Esc] key. The aspect ratio
of displayed images will be adjusted in accordance with the monitor.
Snap shot button
Click this button to take a picture (a still picture). The picture will be displayed on a newly opened window.
When right-clicking on the displayed image, the pop-up menu will be displayed. It is possible to save the
image on the PC by selecting "Save" from the displayed pop-up menu.
When "Print" is selected, printer output is enabled.
Note
•
The following setting may be necessary when using Microsoft Windows 7 or Microsoft Windows
Vista.
Click "Internet Options" on the Tools menu of Internet Explorer, and then click the [Security] tab.
Select "Trusted Sites", and click "Sites". Register the camera address on the "Website" in the
"Trusted Sites" window.
Mic input button
Turns on/off the audio reception (hear audio from the camera on a PC). This button will be displayed only
when "Mic input", "Interactive(Full-duplex)" or "Interactive(Half-duplex)" is selected for "Audio transmission/
reception" on the setup menu. (®page 124)
When this button is clicked, the button will turn into the
heard.
Audio volume can be adjusted (Low/ Middle/ High) by moving the volume cursor
14 Operating Instructions
*4
: Left-click on the control pad to adjust the horizontal/vertical position of the camera
*4
*4
*5
button and audio from the camera will not be
.