Table of Contents
Advertisement
Error message
The error message "E101" or "E104"
appears on the clock display.
The error message "E010", "E310",
"E009" or "E309" appears on the
clock display.
Replacing the oven light bulb
It is possible to replace the oven light. Heat-resistant 12 V,
20 W halogen bulbs can be obtained from After-sales Service
or a specialist retailer.
ã=
Risk of electric shock!
Never replace the oven light when the appliance is switched on.
Pull out the mains plug or switch off the appliance at the circuit
breaker in the fuse box.
Note. Always remove the new halogen bulb from the packaging
using a dry cloth. This increases the service life of the bulb.
Method
Switch off the circuit breaker in the fuse box.
1.
Place a tea towel in the cold oven to prevent damage.
2.
Remove the glass cover. To do so, prise open the glass
3.
cover at the bottom by hand.
Should you experience difficulties removing the glass cover,
use a spoon to help. (Fig. A)
Remove the bulb and replace with a bulb of the same type.
4.
(Fig. B)
$
After-sales service
Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
E number and FD number
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate bearing these numbers can
be found in the oven. You can make a note of the number of
your appliance and the telephone number of the after-sales
service in the space below to save time should it be required.
Possible cause
The temperature sensor has failed.
Technical malfunction.
%
Remedy/Note
Call the aftersales service. Microwave
operation is possible on its own.
Call the aftersales service.
Refit the glass cover. (Fig. C)
5.
&
Remove the tea towel. Switch the circuit breaker in the fuse
6.
box back on or plug in the mains plug.
Replacing the door seal
If the door seal is defective, it must be replaced. Replacement
seals for your appliance can be obtained from the after-sales
service. Please supply your appliance's E number and FD
number.
ã=
Risk of serious damage to health.!
Never use the appliance if the door seal is damaged.
Microwave energy may escape. Do not use the appliance again
until it has been repaired.
Open the oven door.
1.
Remove the old door seal.
2.
There are 5 hooks attached to the door seal. Use these
3.
hooks to attach the new seal to the oven door.
Note. The presence of the join at the bottom of the door seal in
the centre is technically required.
E no.
After-sales service
O
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
FD no.
15
Hide quick links:
Advertisement
Table of Contents
