OSD Push Button Board
The OSD menus and parameters are accessed by 4 push buttons .
Configuring Your Controller
While your LCD controller is designed to drive a wide range of TFT LCD panels, many aspects
of the ASIC chip's panel interface are programmable through a micro-c ontroller with built-in
EEPROM. Check with the supplier of your controller to find a recommended LCD panel.
LCD with TTL Interface
Refer to the illustration below to configure your controller board for a LCD that accepts TTL
data source.
LCD wits LVDS Receiver Interface
Make sure the kind of receiver of LCD display, and connect it
to right connecter.
When you use the controller subassembly with aLVDS proto-
col-based LCD, you must install the daughter board first. It
consists of LVDS transmitter ICs that convert CMOS/TTL data
into LVDS data s tream.
Installing the LVDS Daughter Board
to mainboard "7 OSD push-button board connector"
"Select"
" Manual"
"+"
"-"