Fireplace Dimensions - Empire Comfort Systems VFLL38FP30LN-1 Installation Instructions And Owner's Manual

When planning a fireplace insert installation, it's necessary to
determine:
• Gas supply piping.
• Electrical connections - for optional light kit
MODEL A
VFLL38FP 43-1/4 35-1/4 11-31/32
NOTE: you must use the standoffs that are supplied with the
fireplace. The standoffs are shipped in a flat-state on top of
the fireplace.
1. Locate the two steel standoffs on top of the fireplace.
2. Remove the two screws that secure the standoffs in place;
save the screws.
3. The standoffs have a perforation located in the middle. Bend
them at the perforation.
Page 8

FIREpLACE DIMENSIONS

E
D
C
A
vF FIREpLACE DIMENSIONS (in inches)
B C D
38-1/4
Figure 2
• Electrical supply requirements for optional light.
(120V, 60Hz, 1 Amp)
• Proper opening size of fireplace required for installation of
the fireplace insert.
F
B
G
E F G
41-5/8 11-15/32 1/2
Figure 1
4. Bend the short tabs on each end in opposite directions. Se-
cure the standoffs to the fireplace top with three screws each
from the hardware bag. There are pilot holes located in the
top of the fireplace for each stand-off. See Figure 2
5. Use pliers to bend the side standoffs 90 degrees. See Figure
3.
6. Locate framing bracket package. Install six framing brackets
with two 10 x 1/2 screws (each). See Figures 2 and 3.
K
J
I
H
H I J
10-15/16 15/16 21-1/8
Figure 3
K
13
29516-2-0912