Table of Contents
Advertisement
t
rouBlesHootIng
No .Output
• Check that all your system components are turned on.
• Check your speaker wires and connections.
• Check all interconnecting cables.
• Try hooking up a different set of speakers. The lack of
output could point to a problem with other equipment
in your system (amp, pre-amp, processor, etc.)
Weak . o r . n o . O utput . f rom . E lectrostatic . P anel, . L oss . o f . H ighs
• Check the power cord. Is it properly connected to the
speaker and to the wall?
• Is the power cord connected to a switched outlet?
• Dirt and dust may need to be vacuumed off. Please see
the FAQ regarding vacuuming.
• If using a single-wire connection, check to make sure
that the jumper clips are in place and that the binding
posts are firmly hand-tightened.
• Check the binding posts. Are the dirty? If so clean them
with rubbing alcohol.
• Check the binding posts. Are the loose? Make sure they
are firmly hand-tightened.
• Has a foreign substance (such as a household cleaning
chemical or soap) been applied to the panel? If so the
speaker will require servicing.
Popping .and .Ticking .Sounds, .Funny .Noises
• These occasional noises are harmless and will not hurt
your audio system or your speakers. All electrostatic
speakers are guilty of making odd noises at one time or
another. It is the result of airborne contaminates (most
notably dust). Vacuuming is recommended.
• These noises may be caused by dirt and dust particles
collecting on the speaker, by high humidity.
• Dirt and dust may need to be vacuumed off. Please see
the FAQ regarding vacuuming.
2
Troubleshooting
Exaggerated .Highs, .Brightness
• Check the toe-in of the speakers. Read the Placement
section of this manual for more information.
Muddy .Bass
• Check placement. Try moving the speakers closer to the
front and sidewalls.
• Check the type of feet that are being used. Try attaching
the coupling spikes.
• Possibly means low electrostatic panel output. See
'Weak Output from Electrostatic Panel, Loss of Highs'.
Lack .of .Bass, .No .Bass
• Check your speaker wires. Is the polarity correct?
• Check your speaker wires. Is the woofer working?
• Check your speaker wires if bi-wiring.
• If using a single-wire connection, check to make sure
that the jumper clips are in place and that the binding
posts are firmly hand-tightened.
• Check the binding posts. Are the dirty? If so clean them
with rubbing alcohol.
• Check the binding posts. Are the loose? Make sure they
are firmly hand-tightened.
Poor .Imaging
• Check placement. Are both speakers the same distance
from the walls? Do they have the same amount of toe-
in? Try moving the speakers away from the back and
sidewalls.
• Check the polarity of the speaker wires. Are they con-
nected properly?
• Try switching the left speaker with the right.
• Are your speakers set up in an L-shaped room? If so,
you may experience off-center imaging. Talk to your
dealer about acoustical room treatment options.
Advertisement
Table of Contents
