Assembling The Toddler Adapter - Go-Go Babyz Infant Cruizer Safety, Assembly & Operating Instructions

Assembly Instructions
BEGIN BY REMOVING YOUR
INFANT SEAT AdapterS
1. In order to attach the Toddler Adapter
onto your Infant Cruizer, you must first re-
move the Infant Seat Adapters from the base
of the Infant Cruizer.
Locate your Infant Seat Adapters by removing
your infant car seat from the Infant Cruizer and
extending the handle into the upright, locked
position.
You will have 4 or 8 Phillips screws (depen-
dent upon which adapter you have) which will
need to be removed. Once the screws are
removed, you can take the Infant Seat Adapt-
ers off the base of the Infant Cruizer and store
for future use.
WIPE THE BASE OF THE INFANT
CRUIZER CLEAN
2. Take a rag and wipe your base clean
prior to inserting your toddler Adapter.
IDENTIFY WHERE THE SCREW HOLES
ARE ON YOUR TODDLER Adapter
3. Find the holes on the Toddler Adapter. You
will have 2 holes on the shoulder and 4 holes
on the bottom.
Place the Toddler Adapter onto the base of the
Infant Cruizer (it will snap into place).
Use a Phillips screwdriver to insert the 4
screws through the bottom of the Toddler
Adapter down to the base of the Infant Cruizer.
Next remove the rear ladder strap, buckle
strap and screws from the bag and place
one of them into the matching holes on the
shoulder of the Adapter. (see top left image on
page 9) Make sure the front and back ladder
straps are on one side (left or right) and both
buckle straps are on the other side before as-
sembling. Use the remaining screws to attach
both the ladder strap and the buckle strap to
the Adapter and the main body of the Infant
Cruizer.
8
Peg Perego
Adapters
Graco
Adapter
Shown on base of
Infant Cruizer.
Britax
Adap
ters
Arrows Pointing to
Adapter Holes
ASSEMBLY INSTRUCTIONS