Quick Assembly Guide - Go-Go Babyz Infant Cruizer Safety, Assembly & Operating Instructions

Quick Assembly Guide:

# 1 Remove infant seat Adapters from the bottom of the Infant Cruizer base.
# 2 Snap Toddler Adapter in place.
# 3 Screw down Toddler Adapter onto
Infant Cruizer base with the four screws
included in the box.
# 4 Remove 2 screws, ladder strap
and buckle strap from bag and attach
in the rear (figure 1).
using with a Convertible/Toddler Car Seat:
# 5 Place toddler seat on the base
facing forward. (figure 2)
# 6 Thread ladder straps through front
and rear openings of the toddler seat.
# 7 Tighten straps with ratchet buckle
until seat does not move. Adjust strap
length as needed.
#8 Removal:
Pull on the ratchet
release mechanism with your thumb
and pull strap out from your
Convertible car seat.(figure 3)
Repeat for both straps.
QUICK ASSEMBLY GUIDE
figure 3
figure 1
figure 2
5