Attaching & Removing Your Convertible Car Seat - Go-Go Babyz Infant Cruizer Safety, Assembly & Operating Instructions

Attaching & Removing Your
Convertible Car Seat
SET YOUR CAR SEAT ONTO THE
INFANT CRUIZER
Extend the Infant Cruizer handle into the up-
right, locked position.
Set your Convertible Car Seat onto the Infant
Cruizer facing forward.
Thread the rear adjustable ladder strap (lo-
cated near the handle of the Infant Cruizer)
though the back of the Convertible Car Seat.
(Just like you would thread a car seat belt
when attaching in your car forward facing)
Insert adjustable ladder strap into buckle on
other side of your Infant Cruizer.
Adjust the length of the ladder strap as need-
ed in order to reach the buckle or take up
slack.
DO NOT TIGHTEN UNTIL YOU HAVE
THREADED YOUR FRONT STRAP
THROUGH THE FRONT OF YOUR CAR
SEAT.
Locate the front strap and thread through the
front of your Convertible Car Seat. (Just like
you would thread a car seat belt when attach-
ing in your car rear facing). Insert ladder strap
into buckle.
Use the buckle like a ratchet to tighten the
Straps/Buckles
strap. Adjust the length of the ladder strap as
needed to reach buckle or take up slack.
DO NOT OVERTIGHTEN
TO REMOVE YOUR CAR SEAT FROM
THE INFANT CRUIZER
Pull on the ratchet release mechanism with
your thumb and pull strap out from your Con-
vertible car seat.(bottom figure) Repeat for
both straps.
10 ATTACHING