Power On Message And Function; Power On Message; Function Message - Kenwood TH-78A Instruction Manual

In this mode, the microphone sensitivity and receive audio are reduced automatically to prevent howling. The
transmitter output power is also automatically set to the
power by pressing the F key, then pressing the D/LOW key.
To cancel this function, repeat the procedure for setting the function. The DUP indicator disappears from the display.
POWER ON MESSAGES AND FUNCTION MESSAGE
1

Power On Message

When you first switch the POWER on, "TH 78A" appears on the display for two seconds. You can change this
factory-set message to your own message as follows:
Changing Power-On Message
1 Select your message by following steps 1 to 4 of the memory write procedure on page 36.
Press the 0 key.
2
The power-on message has now been changed. If you switch the power off and on again, your own message
will be displayed on the display for two seconds.
Note
The above message, which is stored in message memory channel0, appears each time you
switch the power on.
2

Function Message

When you select a function, the corresponding function message is displayed on the LCD for two seconds. The
message and functions are listed below:
AF CHG Transpose the two AF bands
AF INI Initial AF output setting
AF MIX Mix the AF output from both bands
AF SEP
Separate the AF output into two bands
AS OFF
Automatic offsets OFF
AS ON
Automatic offsets ON
BELL 1 Tone alert (Telephone type ring)
BELL 2 Tone alert (Tone alarm)
BP OFF Beep OFF
BP ON Beep ON
DTMF0S No DTMF signal transmission delay time
EL
position. You can select the desired transmitter output
Page 46