General Information; Service Literature; Using This Manual; Standard Torques - HUSTLER M1 Owner's Manual

General Information

This Manual covers the Hustler M-1 model 929208.

Service Literature

Note: When ordering parts, you must use the part number as shown for each part, not the index number. Always give
the model and serial number to your parts and service representative.

Using this manual

Illustrations used were current at the time of printing, but subsequent production changes may cause your machine to
vary slightly in detail. Excel Industries, Inc. reserves the right to redesign and change the machine as deemed neces-
sary, without notification. If a change has been made to your machine which is not reflected in this parts manual, see
your Hustler dealer for current information and parts.

Standard Torques

The following chart lists the standard torque values for the threaded fasteners found in this manual. Torque all cap
screws, nuts and set screws to these values unless a different torque is shown in the Notes section next to the fastener.
108548_0711
PART NO.
108548 OWNER'S MANUAL
601825 HONDA GXV160 ENGINE MANUAL
SIZE FT-LBS N-M
.250 8.2 11.1
.312 17 23
.375 30 40
.438 48 65
.500 73 99
.562 105 143
.625 145 200
.750 260 350
.875 420 565
1.00 625 850
DESCRIPTION
SIZE FT-LBS
M3 1
M4 2.2
M5 4.5
M6 7.7
M8 18.5
M10 37
M12 64
M14 80
M16 160
M20 320
M24 555
6-3
N-M
1.3
3
6.1
10.4
25
50
87
108.5
215
435
750