(2). Adventure 800 with CD / USB Player. ( Fig. 2 ) This device complies with Part 15 of the FCC Rules. Operation is subject to the (3). Adventure 800 with CD / USB Player & Digital Recorder. ( Fig. 3 ) following two conditions: (4).
Page 3
Maintenance-free Lead Acid battery Rear panel configuration ( CD / USB Player ) Guidelines for maintenance-free Batteries: 1. Battery should operate at temperatures between 15°C ~ 50°C. To ensure a longer life span, it should be kept between 5°C ~ 35°C. For optimum result, 20°C ~ 25°C will be ideal. When temperature falls 15 degrees below zero, battery will undergo some changes in its chemical contents and therefore cannot be recharged.
Page 4
Adventure 800 with CD / USB Player & Digital Recorder Input Level Gain Control Adjustment Low impedance ( Lo-Z ) " MT" & high impedance ( Hi-Z ) " GT" gain controls are situated inside the transmitter as shown in Fig 10. Gain controls are adjustment ports that enable you to use microphones of differing output levels and Guitar or instruments with Hi-Z output.
VHF Belypack Transmitter M-1002 Adventure 800 with CD / USB Player & Tape Deck Par ts & Fu nc tion s Power Switch Battery status indicator. MIC cable MIC IN socket Belt clip ( hidden behind ) Battery compartment Battery...
Page 6
Adventure Companion Speaker (WA-517) Beltpack Transmitter SM-816(UHF) / SM-216(VHF) Battery installation This transmitter uses 3 pieces of " AA " size batteries (Alkaline battery is recommended ). To install or remove the batteries, press the release buttons at the edges of the transmitter to open or close the cover as illustrated ( Fig.1 ).
Page 7
The Power Supply and basic Battery Management To prevent contact noise caused by constant tension The power supply of Adventure 800 system comes from the two pieces of 12V / 4.5 AH applied to the connector,,a cable restraint is designed...
Page 8
Operating the Wireless Microphone System Beltpack Transmitter SM-916(UHF) / SM-316(VHF) To use the First wireless system, switch on the receiver module power supply switch of WM1. Switch on the corresponding matching transmitter or handheld microphone ( please Battery installation refer to the operating instruction of the individual transmitter ). When RF signal is being received by the receiver, the receiver RF signal indicator 1 will light up.
Page 9
Front remotable is an unique feature of Adventure 800. User can easily control this CD player by clicking its remote from both front and rear Adventure 800. To begin operation switch on the CD Power after the main power of Adventure 800 has been turned on.
Page 10
UHF Beltpack Transmitter SM-5016 In stop mode: Skip the starting play folder to previous folder during stop mode, cyclic to the last folder if it is in the first folder. Parts & Functions FOLDER- In program entry mode: DOWN Change the file for program select to previous folder's first file, cyclic to Antenna the last folder if it is in the first folder.
VHF Handheld Transmitter Q-1002 Operating the Digital Recorder Parts and Functions Product Features : 1.Digital record to MP3 compression format Battery status LED indicator 2.Highest sample rate at 44.1KHz, 128Kbps (as CD quality). Battery compartment cover 3.1 - 99 recording tracks. 4.Equiped with 128MB flash memory for 60 min.
Page 12
Handheld Transmitter SQ-816(UHF) / SQ-216(VHF) Parts & functions 4.Key control 4-1 Power key 4-2 Upper key: Upper key for track selection. Track number will move quickly when push still 1. Capsule with metal grille for two seconds (this function will not work in MP3 mode). 2.
5. MODE key------ Push the MODE key with another key for special function selection. The Changing of capsule LCD will show "MODE" when push MODE key, you shall push another This microphone has a modular design. To change or replace a capsule, Open the grill to function key to perform the function.
9. Please use the one with cooperate specification (marks on the back of the machine). Handheld Transmitter SQ-916(UHF) / SQ-316(VHF) Please turn off the power when you do not use the machine for a period of times. * To keep stable data transmission, please do not twist the USB cable during data transmission. * Please do not press the LCD monitor heavily, or touch it with finger or sharp articles.
Page 15
Operating the Tape Deck Keys Functions PLAY Press this key to play the tape. Press this key together with PLAY key for recording. PAUSE Press this key to pause the play. Press again to continue the play. F.FWD Press this key for fast forward . Press this key for fast reverse.
Simple DIY Trouble-shootings: UHF Handheld Transmitter SQ-5016 1. No sound when speaking into the wireless microphone Parts and functions Please verify the followings : 1.1 Main power switch should be ON. When no light appears, it means that the battery is weak. ¡@ Please plug in the AC cable to charge the battery.
Need help?
Do you have a question about the Adventure 800 and is the answer not in the manual?
Questions and answers