Table of Contents
Advertisement
Timer Reset: Pressing the auto shutoff shuts the machine down after one hour. The timer reset
allows for another hour of use.
Standby Mode: Lowers temperature to 150° cutting energy use in half.
Heat Control
Your new Easy-Lam green™ has a digital heat controller. Users can easily adjust the set
temperature for the heat shoes to achieve the best quality lamination. The controller has been
calibrated to accurately display the heat shoe temperature in the laminating range.
The heater switch on the left side cover activates the controller. When the switch is turned on the
controller will flash a two letter code and then display the heat shoe temperature. When cold, the
temperature displayed on the controllers may be different than the actual ambient temperature to
account for correction in the higher temperature range. When the heater switch is turned on, the
controller will send power to the heaters, provided the Set Temperature is higher than ambient
temperature. (For safety reasons, this machine was shipped with the Set Temperature at 250).
When power is being sent to the heaters the controller will illuminate a small red indicator light in
the lower right hand corner of the display. The light goes out when the Set Temperature is
reached. Power to the heaters will cycle when the heat shoe temperature falls below the Set
Temperature during lamination or while sitting idle.
OPERATION
This section describes the operation of your Easy-Lam green™. This laminator is designed for all
widths of plastic up to 27". However, if narrower widths are used the Heat Shoes must be
cleaned before using a wider roll. Refer to the MAINTENANCE section for cleaning instructions.
Loading Laminating Film onto Mandrels...
Slide the film onto the mandrel making sure that the mandrel spring is in position to compress
properly when the film is pushed onto the mandrel. Remove the film in the same direction.
Threading Laminating Film...
These instructions apply to poly-in film rolls (shiny side out, dull side in)
1. For the top supply roll place the mandrel ends into the slots in the top of the laminator. If you
are facing the front of the laminator the film should unwind toward you from the bottom of the roll
as in Figure 3 below.
Figure 3
7
Advertisement
Table of Contents
