Operator's Manual J-handle set 123L p. 2-6 Read through the Operator‘s Manual carefully and understand the content before using the machine. These instructions supplement the instructions that were included with the machine. For other procedures, please refer to the operating instructions for the machine. Manuel d'utilisation Kit de poignée en J 123L p.
Husqvarna AB has a policy of continuous product development and therefore reserves the right to modify the design and appearance of products without prior notice. Read through the Operator‘s Manual carefully and understand the content before using the machine. These instructions supplement the instructions that were included with the machine.
SAFETY INSTRUCTIONS Cutting equipment This section describes how through correct maintenance and through using the right type of cutting equipment you can: • Reduce the machine‘s tendency to kickback • Obtain maximum cutting capacity. • Increase the service life of the cutting equipment. The three basic rules: 1)Only use the cutting and guard equipment...
• Grass trimming is a general term for light clearing, e.g. around edges or around trees. A trimmer head or plastic blade is used. WARNING! Sometimes grass can collect in the spray guard and cutting head. Always stop the engine when cleaning.
Assembling the J-handle WARNING Only grass blades or trimmer heads/ plastic blades may be used when the J- handle is fitted. Clearing blades must never be used with the J-handle. • Clip the loop handle onto the shaft. Note that the...
Replace the guard if it is exposed to impact or is cracked. • Check that the trimmer head and spray guard are not damaged or cracked. Replace the trimmer head or spray guard if they are exposed to impact or are cracked.