Brother QL-710W Quick Setup Manual page 31

6-1
Enter the Network Key you
noted in MEMO
and then click [Next].
If your network is not configured
for authentication and
encryption, the ATTENTION!
screen will appear. To continue
configuration, click [OK] and go
7-1
to .
7-1
Confirm the wireless network
settings and then click [Next].
The settings will be sent to
your printer.
• The settings will remain
unchanged if you click
[Cancel].
• If you want to manually assign
an IP address to the printer,
click [Change IP Address]
and enter an IP address that is
compatible with your network.
• If the wireless setup failure
screen appears, click [Retry].
8-1
Disconnect the USB cable
connecting the computer and
the printer and then click
[Finish].
Wireless setup is now complete.
Go on to 9 to install the printer
driver and the software.
page 21
For Method 2 users
4-2
Confirm that your WLAN
access point/router has the
WPS symbol.
5-2
Place your printer within range
of your WPS access point/
router. The range may differ
depending on your
environment. Refer to the
instructions provided with your
access point/router.
6-2
Turn on your printer and press
and hold the Wi-Fi button until
the (Wi-Fi) indicator
starts blinking in green.
7-2
Press the WPS button on
your WLAN access point/
router. When the configuration
is completed, the
(Wi-Fi) indicator on
your printer lights in green.
Wireless setup is now
complete. Go on to 9 to install
the printer driver and the
software.
29