Installing The Camera On A Surface; Step 1: Unpack The Camera - LevelOne FCS-3053 Hardware User Manual

Hardware Manual

Installing the Camera on a Surface

This section describes the procedures in installing the camera directly on a flat surface, such
as the ceiling or the wall. For simplicity, most of the camera images used in the succeeding
sections were taken using the camera model with heat sink; same procedures apply to the
model without heat sink unless specified.

Step 1: Unpack the Camera

NOTE: To avoid scratches or leaving fingerprints on the dome cover, it is recommended to
retain the plastic covering the dome cover until the camera is completely installed.
1. Slide the mounting plate counter-clockwise to detach it from the camera.
2. Remove the silicon bag.
8