Antenna Setup - Digital; Channel Memory Setting; Channel Strength - Sharp Aquos LC-42D62U Operation Manual

Basic adjustment settings
Channel memory setting
Press MENU to display the MENU screen,
and then press ......
/~
to select "Setup".
Press
J.IT
to select "CH Setup", and then
press ENTER.
• If you already set the Secret No., input the
4-digit secret number here. See page 39 for
setting a secret number.
Press
J.IT
to select "CH Memory", and then
press ENTER.
Press
j./T
to select "Signal Strength".
• The signal strength of DIGITAL channel is
displayed. The signal information is based on
the current channel.
Press MENU to exit.
Press
J./T
to select "Channel Strength",
and then press
ENTER.
Input the 2-digit channel number to check
the signal strength of the selected channel.
• Make sure the signal is strong enough for each
channel.
Channel Strength
The channel signal strength can also be checked
separately.
Repeat steps 1 to 2 in Signal Strength in
Antenna Setup - DIGITAL
When viewing ANALOG broadcasts:
CD
Press
~/~
to select the channel to skip, and
then press
T
to move down.
®
Press .....
/~
to select "On", and then press
ENTER.
When viewing DIGITAL broadcasts:
CD
Press ..
IT
to select the channel to skip, and
then press .....
/~
to select "On".
Press ..
IT
to select ANALOG (Air), ANALOG
(Cable), DIGITAL (Air) or DIGITAL (Cable), and
then press ENTER.
Press
MENU
to exit.
• On: Skips channels. (Channel selection disabled using CH
A/V·)
• Off: Does not skip channels. (Channel selection enabled
using CH
A/V.)
• Make sure what kind of connection is made with your 1V.
Press MENU to exit.
In order to receive digital air broadcasts, you need a
digital broadcast antenna. You can confirm the antenna
configuration through the "Antenna Setup - DIGITAL"
screen.
• This function is available for DIGITAL (Air) only.
If necessary, adjust the direction of the antenna to
obtain the maximum signal strength.
Signal Strength
Press MENU to display the MENU screen,
and then press ......
/~
to select "Setup".
Press
J.IT
to select "Antenna Setup -
DIGITAL", and then press ENTER.
@-23