Power Saving Mode - Toshiba RAV-SM564UT-E Owner's Manual

Unit select button
• When multiple indoor units are controlled with one
remote controller, louver direction can be set for
each indoor unit by selecting individually.
• To set louver direction individually, push
button to display an indoor unit number in the control
group. Then set the wind direction of the displayed
indoor unit.
• When no indoor unit number is displayed, all indoor
units in the control group can be controlled
simultaneously.
• Each time button is pushed, the display
changes as follows:
UNIT No. UNIT No. UNIT No.
1-1 1-2 1-3
Not UNIT No.
display 1-4
How to set louver wind
direction individually
1
Select an indoor unit to be set by pushing
(left side of the button) during
operation.
• The indoor unit number changes each time you
push the button.
Unit No. Unit No. Unit No.
1-1 1-2 1-3
Not Unit No.
display 1-4
* When no unit number is displayed, all indoor units
are selected.
2
Select a louver you want to adjust change by
pushing (right side of the button).
• Each time you push the button, the display on
the left of the remote controller changes as
follows:
Not
display
* When no louver number is displayed, all four louvers
are selected.
Louver No.
17-EN
03
Refrigerant
pipe
04 02
Drain
pipe
01
3
Determine wind direction of the selected
louver by pushing .
• Each time you push the button, the display
changes as follows:
(1) (2) (3) (4)
(7) (6) (5)
* During COOL (DRY) mode, (4) and (5) are not
displayed.
– 9 –
7

Power saving mode

The power saving mode saves energy by limiting the maximum current which will effect heating or cooling capacity that the unit
can generate.
Push button during operation.
• The air conditioner enters power saving mode.
• appears on the display.
Power saving mode will stay in effect until it is cancelled.
To cancel the power saving mode, push
• disappears.
To configure the power saving mode settings
When RAV-SP***2AT / RAV-SM***3AT or older is used, the displayed setting changes, but the actual power level is always "75
%".
5
1
Push button for at least four seconds when the air conditioner is not working.
• , symbol, and numbers flash.
2
Push (left side of the button) to select an indoor unit to be set.
• Each time the button is pushed, UNIT No. change as follows:
UNIT No.
The fan of the selected unit runs.
button again.
1
3
2
4
UNIT No. UNIT No.
1-1 1-2 1-3
UNIT No.
1-4
18-EN