Table of Contents
Advertisement
ASSEMBLY, CONTINUED
To install the legs, first place the back of the grill flat on the ground. Each leg attaches to four
holes in the bottom of the grill. While holding each leg, insert and tighten the four washers
and bolts, using a ½" socket. (In case of the need to replace this part, use the reverse of this
procedure.)
If using the optional cabinet, the legs will not be needed.
Optional cabinet installation: The bolts that are intended for the legs will be used for the
optional cabinet. Place the main body of the grill onto the cabinet and install the washers and
bolts into the holes in the bottom of the grill, using a ½" socket. *The cabinet will need to be
assembled first; those instructions will be included with the cabinet.
WARNING: NO
COMBUSTIBLES SHOULD BE
PLACED IN THIS OPTIONAL
CABINET. DOING SO COULD
CAUSE A FIRE OR
EXPLOSION RESULTING IN
INJURY OR DEATH.
The grill's door thermometer will also need to be installed. Put the probe end of
the thermometer in the hole in the right side door, and put the wing nut on and
tighten by hand.
7
Hide quick links:
Advertisement
Table of Contents
