Assembly - England's Stove Works 21-PG100 User Manual

When you receive your grill, a few parts will need to be assembled before you begin using your
appliance. First, remove your manual, drip pan, the front and side shelves, and the legs. All of
the hardware for attaching these will be included in the manual packet. You will need a ½"
socket to attach the shelves.
The grease bucket will hang just to
the bottom right of the grill, on
the drain tube.
The longer shelf and heat shield must be attached to the four holes in the front of the grill.
Before trying to install the legs/front shelf, lay the grill on its back. (This will allow for easier
assembly.) First place the heat shield, with the holes lined up, on the front side of the grill.
Then place the shelf on top of the heat shield with the holes in the shelf lined up with the
shield. Then insert the four ½ bolts and washers in the four holes and tighten using a ½"
wrench/socket.
The shorter side shelf attaches to the four holes in the side of the grill. While holding up the
shelf, insert and tighten the four washers and bolts, using a ½" socket. (In case of the need to
replace this part, use the reverse of this procedure.)
ASSEMBLY
6