Table of Contents
Advertisement
COMPONENT REPLACEMENT, CONTINUED
Door Thermometer
Open the right side door to the grill. Loosen and remove the wing nut on the thermometer.
Then, pull the thermometer out of the door. To replace, put a new thermometer in the
opening and reinstall the wing nut.
Refer to this illustration for the procedures on this page
Thermocouple
Remove the cover panel and the control board (see instructions on Page 18). Then, using a
small flat head jeweler's screwdriver, loosen the two screws that hold the thermocouple wires
in place. (Note which color wires are on which side. The control board should also be marked
with an "r" and a "y" directly next to where the wires are connected.) Next, open the front
doors and locate the thermocouple along the right side of the rear wall of the grill. Using the
5/16" socket, loosen and remove the two screws that hold the thermocouple to the bracket.
You can then pull the wires through and remove the thermocouple (take note as to where the
wires feed through, as you will need to put the new wires back through the same way). To
install the new thermocouple, feed the wires back through and reattach the thermocouple,
using the two screws previously removed. Then reinstall the ends of the wires into the control
board in the same position that they were previously. Reinstall the control board, using the
same screws that were previously removed.
Exhaust hood and chamber
The exhaust hood and chamber are located on the right side of the grill. To remove, use a
5/16" socket to remove the screws that secure the hood and chamber. Be sure to clean the
parts and the side of the grill where the chamber was installed, using a specialty creosote
remover and a scraper.
17
Hide quick links:
Advertisement
Table of Contents
