Sony KLH-W32 Operating Instructions Manual page 58

4:3 Default
Display Area
Horizontal Shift
Vertical Shift
Vertical Size
Reset
PAP Setting
24
GB
"Wide Zoom": Select to enlarge the 4:3 picture to fill the 16:9 screen, keeping the
original image as much as possible.
"4:3": Select to display the 4:3 picture without changing its aspect ratio.
"Full": Select to enlarge the 4:3 picture horizontally only, to fill the 16:9 screen.
"Zoom": Select to enlarge the 4:3 picture to fill the screen while keeping its aspect
ratio.
"Off": Select to continue using the current "Wide Mode" setting when the input is
changed.
Tips
• You can select "4:3 Default" only when "Auto Wide" is set to "On".
• "4:3 Default" functions only when the display receives NTSC, PAL, SECAM, 480i, 480p,
575i or 576p signals.
• If "Wide Mode" setting is changed after "4:3 Default" is set, the "Wide Mode" setting will
become effective and the aspect ratio of the screen will change. This setting change that was
made afterward by "Wide Mode" will be effective only when each signal is input. Therefore,
when the input signal is changed, the screen will return to the original "4:3 Default" setting.
To keep the current aspect ratio even after the input signal is changed, set "4:3 Default" to
"Off".
"Normal": Displays a standard size picture.
"-1"/"-2": Allows you to adjust the viewable picture area size. When noises appear
around the picture, select this to hide the noises.
Allows you to move the position of the picture left and right in the window.
Available only in "Wide Zoom" and "Zoom" modes. Press G/g and press
choose a correction.
Allows you to move the position of the picture up and down in the window.
Available only in "Wide Zoom" and "Zoom" modes. Press F/f and press
choose a correction.
Allows you to adjust the vertical size of the picture. Available only in "Wide Zoom"
and "Zoom" modes. Press F/f and press
Resets the following settings; "Horizontal Shift", "Vertical Shift" and "Vertical
Size" to the default settings.
Allows you to show two pictures from different signal sources, such as a PC and a
video, side by side. Only the combination of an analog signal and a digital signal is
available.
"PAP": "On" shows two pictures side by side at the same time, and "Off" disables
"PAP" function.
"Swap": "OK" swaps the position of the two pictures, and "Cancel" aborts the
execution.
"PAP Size":
"Large Left": The left picture's width is larger than the right picture.
If the left picture's aspect is 4:3, the left picture's height will be equal to the panel
size.
"Even": The left picture and the right picture width is the same (half & half). The
height will be set to match each picture's aspect ratio.
"Large Right": The right picture's width is larger than the left picture.
If right picture's aspect is 4:3, the right picture's height will be equal to the panel
size.
Notes
• When two pictures are displayed, the "Picture" settings set when a single picture is displayed
are applied.
• For details on the available combination of two pictures, see page 15.
to choose a correction.
to
to