Related Manuals for Aquatic SERENITY DRIFTBATH
Summary of Contents for Aquatic SERENITY DRIFTBATH
- Page 1 OWNER’S MANUAL & INSTALLATION GUIDE Note: Read all instructions before proceeding with installation. All specifications are ± 1/4’’ and are subject to change without notice. Dimensions listed in inches (mm).
-
Page 2: Table Of Contents
Serenity DriftBath Owner's Manual & Installation Guide TABLE OF CONTENTS PRODUCT REGISTRATION INFORMATION CONGRATULATIONS! IMPORTANT SAFETY INSTRUCTIONS PRE-INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS Structural Preparation 7 - 8 Plumbing DriftBath with Chromatherapy LED Lights OPERATION INSTRUCTIONS Bath-side On/Off Controls DRIFTBATH USER INFORMATION... -
Page 3: Product Registration Information
Your product warranty is registered and confirmed with Aquatic through the Serial Number on your unit. You do not need to contact Aquatic to confirm registration. Please fill out the information below and reference when contacting the distributor to expedite warranty claims. -
Page 4: Congratulations
Serenity DriftBath Owner's Manual & Installation Guide CONGRATULATIONS! You have chosen one of the finest bath products in the world! Aquatic supports your purchase with strong commitments to quality and customer satisfaction. Please read and follow all of the instructions contained in this Owner’s Manual before installing, operating or maintaining your DriftBath. -
Page 5: Important Safety Instructions
WARNING: WHEN USING THIS UNIT, THESE BASIC PRECAUTIONS SHOULD BE FOLLOWED. This manual contains information and instructions for proper operation and maintenance of your Serenity DriftBath. Failure to follow these instructions could result in personal injury, electrical shock or fire. -
Page 6: Pre-Installation Instructions
6. Plug in pump cord and run pump for 10 minutes. 7. Inspect the tub completely. Any defect must be reported to Aquatic prior to installation in order to have it covered by warranty. Should inspection indicate any damage or leaks, do not install the bath. -
Page 7: Installation Instructions
Serenity DriftBath Owner's Manual & Installation Guide INSTALLATION INSTRUCTIONS STRUCTURAL PREPARATION: Note: The bath should remain in its shipping carton until time of installation. 1. Literature dimensions are for reference only. Installation dimensions should be taken directly from the tub. An access panel of 16”... -
Page 8: Plumbing
INSTALLATION INSTRUCTIONS STRUCTURAL PREPARATION (CONTINUED): 6. Another installation option is that of a tile flange. Aquatic offers a factory installed tile flange for all rectangular and corner-unit tubs. 7. Install the bath unit per the instructions provided in this manual. -
Page 9: Driftbath With Chromatherapy Led Lights
Serenity DriftBath Owner's Manual & Installation Guide INSTALLATION INSTRUCTIONS DRIFTBATH WITH CHROMATHERAPY LED LIGHTS Pump Breaker Panel White Neutral 15amp 1 pole TEST RESET GFCI Breaker Ground Black Load Light Wire the electrical outlet as in the above figure to a minimum 20 amp, 120 vac dedicated circuit breaker which is GFCI protected (not supplied). -
Page 10: Operation Instructions
Serenity DriftBath Owner's Manual & Installation Guide OPERATION INSTRUCTIONS BATH-SIDE ON/OFF CONTROLS: ON/OFF Pump ON/OFF LIGHT 1st Press: Light ON - WHITE 2nd Press: Light OFF Turn OFF and ON within 3 seconds the light will change to: SLOW - RAINBOW CYCLE;... -
Page 11: Driftbath User Information
Serenity DriftBath Owner's Manual & Installation Guide DRIFTBATH USER INFORMATION PLEASE NOTE: No servicing of this product should be done by the user. There are no user serviceable parts. All controls are located in the control recesses on the lip of the tub. These are the only controls that should be used by the consumer. Do not change or alter any of these controls under any circumstances. -
Page 12: Care And Maintenance
SUPER SYSTEMS CLEAN PLUS manufactured by Stearns Packaging Corporation to rectify this condition. This may be obtained by calling Aquatic, at (800) 945-2726. It is recommended that you follow the instructions provided by the manufacturer with the product. Repeated use may be necessary. SUPER SYSTEMS CLEAN PLUS does not replace the necessity to purge your DriftBath system at least twice a month with a low foaming detergent and bleach. -
Page 13: Water Quality
Serenity DriftBath Owner's Manual & Installation Guide WATER QUALITY CHEMICAL & WATER QUALITY Owners of fill and drain whirlpool bathtubs need to know basic information concerning water quality, how it affects the performance and enjoyment of the operation of their tubs, and steps that can be taken by the owner to correct related problems. - Page 14 SUPER SYSTEMS CLEAN PLUS manufactured by Stearns Packaging Corporation to rectify this condition. This may be obtained by contacting Aquatic at (800) 945-2726. It is recommended that you follow the instructions provided by the manufacturer with the product. Repeated use may be necessary. SUPER SYSTEMS CLEAN PLUS does not replace the necessity to purge your whirlpool system at least once a month with a low foaming detergent and bleach.
-
Page 15: Troubleshooting Guide
Serenity DriftBath Owner's Manual & Installation Guide TROUBLESHOOTING GUIDE WARNING: Always turn off power at the main electrical service panel when servicing your tub. SYMPTOMS POSSIBLE PROBLEMS SUGGESTED SOLUTIONS Motor does not start 1) GFCI or circuit breaker in OFF position. -
Page 17: Aquatic Limited Warranty
You must be the Purchaser of the tub. You must give prompt written notice to Aquatic at the address detailed below of any defect claim within the warranty period and provide us with any substantiation that we may reasonably request. - Page 20 AQUATIC Fax-On-Demand System: Toll Free (877) 618-7024 02/13 8101 E. Kaiser Blvd. • Anaheim, CA 92808 (800) 945-2726 • Fax (866) 544-5353 • www.aquaticbath.com 8MANDBTH | F.O.D. 9009...