Advertisement
Available languages
Available languages
DSL70HB/HW
10/13/03
Feed the supply wires from the house (coming through the lamphold-
er mounting plate hole) through the mounting plate adapter hole (L).
The threaded end of the mounting plate adapter should be
facing the lampholder mounting plate. NOTE: If the house lead wires
are not long enough, it may be necessary to attach 6" wire exten-
sions.
4. Screw the mounting plate adapter into the lampholder mounting plate.
NOTE: Use the locknut to adjust and tighten
the adapter to the mounting plate.
5. Apply silicone caulk around the mounting
plate adapter to ensure a watertight seal.
6. Mount the fixture to the mounting plate adapter using the 3 screws
and nuts provided (M). House supply wires should be in the
bottom area of the fixture arm at this point.
7. Make wiring connections inside the fixture arm as described in
"Wiring your fixture."
Wiring your fixture
Before continuing – turn off the power at the main fuse/breaker box.
If the supply wires coming from your house
are solid, you can use the Quick-connect™
wire system to attach your Regent light
fixture. NOTE: Quick connectors can only be
used with solid supply wires.
1. Simply insert the black supply wire from your
house into the quick connector with the black wire coming
from the fixture (N).
2. Attach your ground supply wire to the green ground wire coming
from your the fixture. Secure with wire nut (not provided).
3. Insert the white supply wire from your house into the quick connector
with the white wire coming from the fixture (N).
4. Push both wires firmly into holes to insure that they
are seated properly and securely.
Proceed to "Attaching access cover and lens."
If the supply wires coming from your house are stranded:
1. Remove the quick connectors from the end of the light fixture wires by
turning them repeatedly from left to right while pulling. Repeat until
they are both removed. Discard these connectors. Do not attempt
to use with other electrical fixtures! These connectors are
designed to withstand the temperature and voltage requirements
of this Regent product only.
2. Attach your ground supply wire insidethe fixture arm using the
ground screw provided (J).
3. Connect black fixture wire to black supply wire (hot). Secure with wire
nut (not provided).
4. Connect white fixture wire to white supply wire (neutral). Secure with
wire nut (not provided).
5. Be careful to connect the wires correctly. Make sure no bare strands
3:52 PM
Page 4
4
M
N
Fixture
wire
House supply
wire
Advertisement
