Regent DSL70HB Instruction Manual page 3

DSL70HB/HW 10/13/03
the National Electrical Code and local building codes.
• Always use same wattage and type of bulb that was included with the
fixture. Failure to do so will void the warranty.
Putting up your fixture
NOTE: This fixture is intended to be installed either on a standard
lampholder mounting plate, or with conduit, connected to a properly
installed and properly grounded metal weatherproof junction box
(not provided). All coverplates, conduit connections, conduit, and
junction boxes (not provided) should be UL LISTED suitable for wet
locations.
MOUNTING TO WALL OR POST:
1. Using the pattern on the box, mark and drill holes for mounting.
NOTE: This fixture should be mounted in an upright position.
2. Install the two bottom mounting screws first, leaving enough room
between the mounting screws and the mounting surface to slide the fix-
ture into position.
3. Screw the top mounting screw into the predrilled hole and back the
screw out. This will leave the hole threaded and make installation of
the fixture easier.
4. Mount the light fixture (without the access cover) to the mounting sur-
face by setting the fixture on the bottom two screws – from Step 2 (in
the slots on the bottom of the fixture plate), and then screwing the top
screw back into the prethreaded hole. Tighten all screws.
5. Remove the access cover from the hardware bag. With a hammer and
screwdriver, remove the round knock-out from the
access cover (be careful not to damage the access
cover).
6. Install the first conduit connector (not provided) into
the knock-out area of the access cover (J). Tighten
with adjustable wrench. NOTE: The access cover
should not be attached to the unit at this point.
7. Connect second conduit connector at the junction box
(J).
8. Attach conduit between the two connectors.
9. Turn off the power at the main fuse / breaker box. Feed
supply wires into conduit, connecting one end inside junc-
tion box, and the other end to the fixture. Make wiring con-
nections inside the fixture arm as described in "Wiring
your fixture."
MOUNTING TO STANDARD LAMPHOLDER MOUNTING PLATE:
1. Feed the supply wires from the house through the lamp-holder mount-
ing gasket, and through the back of the mounting plate itself (K).
2. Install the lampholder mounting plate to the junction box (refer to the
mounting plate instructions). House supply wires
should be sticking out of the front of the mounting
plate.
3. Screw the locknut (found in the hardware bag) onto
the threaded end of the mounting plate adapter.
3:52 PM Page 3
3
J
K
L