Operating System (Updating) - Charlie Lab Megabeat One User Manual

6.

OPERATING SYSTEM (updating)

The operating system of the Megabeat One is made up of all the commands
and functions which enable the Megabeat One itself to carry out all the operations
described in this manual.
It has been previously loaded by CHARLIE LAB into the hard disk of the
Megabeat One and it is automatically loaded every time the unit is turned on.
Just like in any personal computer it is possible to update this operating
system adding new functions or improving the existing ones.
The updating procedure is very simple since there are no components to be
removed, and the updatings will be supplied in floppy disks.
To start the process you just have to:
1. Insert the updating floppy (the Megabeat One is switched off)
2. Turn on the Megabeat One.
The unit will immediately check if the inserted floppy disk contains a new or
different version of the operating system and if this is the case it will write it into
the Hard Disk. Since the updated operating system is stored permanently in the
Hard Disk memory, you don't need to repeat this operation anymore.
N
OTE
Should the display say " HARD DISK FAILURE ", you may be obliged to load
again the operating system.
Switch off the Megabeat One and then turn it on after a few seconds.
It the display should still show the same message, switch off the unit and
load the operating system as described in this chapter, using the floppy disk
supplied with the Megabeat One (or the latest version of the operating system that
you have).
If the error condition should persist even after the re-loading the operating
system, please contact the nearest customer service centre.
6. O S ( )
PERATING YSTEM UPDATING
62