Ac Connection; Audio Connections - Charlie Lab Megabeat One User Manual

M O U M
EGABEAT NE SER ANUAL
2.1

AC CONNECTION

The Megabeat One comes with its own AC power supply.
Plug the AC adapter into the "AC Adapter jack" (20) on the rear panel of
the machine, then connect the adapter to an AC mains socket.
2.2

AUDIO CONNECTIONS

If your Megabeat One has an inbuilt audio card, you will be able to play the
songs contained on the hard disk without using any other external MIDI
instruments.
In this case you have to connect the Audio Output (15, 16) of the
Megabeat One to a line input of your the mixer, or directly to the line input of PA
(or to the AUX or TAPE input of your Hi-Fi).
Connecting a earphone to the output PHONES (11) on the front panel you
will be able to monitor the audio reproduction without using any external amplifier.
N
OTE
The VOLUME knob (13) on the front panel adjusts the audio level of the
PHONES output and of the audio outputs at the same time.
But, if your Megabeat One has not an internal audio card, the audio
connections should be attached to the sound system used for the audio
reproduction (this audio system will be then connected to Megabeat One via MIDI,
as it is described in the next paragraph).
However, it is possible to use the MIDI connection to drive an external sound
generator even if Megabeat One has the internal audio card (therefore it is possible
to use both internal and external sound generation at the same time).
11