Sliders/Knobs Programming; Slider/Knob Programming - Studiologic VMK-188 plus Instruction Manual

I n s t r u c t i o n m a n u a l
PROCEDURE: SLIDER / KNOB PROGRAMMING
We will set up a SLIDER to behave like an analog mixer fader. Fader Down>min. volume. Fader Up>Max. Vol.
Programing KNOBS follows the Exact same procedure.
TIP: Unlike an analog mixer you might not want your minimum volume to be 0 (no sound). You may just want a track to "sit" in
the mix. Therefore you should choose a value greater than 0. For example, you may want to "ride" a guitar part and not want its
volume to dip below a certain level in the mix. In that case set the Min. to a value that sounds good. Then when you pull the fader
down you'll still hear the guitar without having to worry about fader position. You can reverse this example for Max Values also.
1) PRESS EDIT
2) MOVE SLIDER (KNOB)
In this example Move SLIDER 1
w/Bank A Selected
(Remember: keep track of
your BANKS when programing!)
Move SLIDER (1)
3) PRESS PAGE UP
In this example we'll use
CTRL Change number 10.
You may adjust this to any
CTRL number you desire.
4) PRESS PAGE UP
Set the Value Min. to 0
5) PRESS PAGE UP
Set the Value Max to 127
In this example when the Slider
is pushed UP it will increase to
the Maximum allowed
SCREEN
CHANGE
SCREEN
CHANGE
SCREEN
CHANGE
SCREEN
CHANGE
SCREEN
CHANGE
17
s l i der s/ k nobs
VMK SERIES
PRESS OR MOVE
ANY CONTROLS
To adjust the Midi Channel use the DE knob
EDIT SLIDER 51
MIDI CHANNEL OFF
To adjust the CTRL Change use the DE knob
EDIT SLIDER: 51
CTRL CHANGE: 10
To adjust the Value Min. use the DE knob
EDIT SLIDER: 51
VALUE MIN.: 0
To adjust the Value Max use the DE knob
EDIT SLIDER: 51
VALUE MAX: 127