Super Bright Led, 2-Pin White Plug - Viper 650XV Installation Manual

Door Lock Harness (H2), 3-PIN Connector
___
Green
H2/A
___
Empty
H2/B
___
Blue
H2/C
IMPORTANT! The door lock outputs are low current and should not be attached
directly to any high current device; they are only to be used to activate relays
NOTE: For detailed instructions about connecting to the vehicle's power door lock systems, refer
to the Door Lock Wiring guide (Document No. 1041) available to authorized dealers only from the
technical resources listed at the front of this guide.
Peripheral Plug-In Harnesses

Super Bright LED, 2-Pin WHITE Plug

The super bright LED operates at (+) 2 volt DC and plugs into the two-pin WHITE port. Make
sure the LED wires are not shorted to ground as the LED will be damaged. Multiple LED's can be
used, but they must be wired in series. The LED fits into a 9/32-inch mounting hole. Be sure to
check for clearance prior to drilling the mounting hole.
NOTE: Never use a BLUE LED in combination with a RED LED.
10
(-) Lock, (+) Unlock Output
(-) Unlock, (+) Lock Output
DIA-41
Unless Using 451M
© 2002
Directed Electronics, Inc.