Asko W600 Use And Care Manual page 15

INSTALLA INST ALLATION INSTR TION INSTRUCTIONS
Read these instructions carefully and completely before
you install the machine. The installation should be
carried out by a qualified person who is familiar with all
local codes and ordinances for electrical and plumbing
connections.
SPECIFICA SPECIFICATIONS TIONS
Height 33-1/2"–34-1/2 (850–876 mm)
Width 23-7/16" (595 mm)
Depth W640/W660: 23-7/16" (595 mm)
W600/W620: 24-7/16" (620 mm)
Weight 167 lbs. (73 kg)
Rated load See data plate
Supply voltage Single-phase 230 V, 60 Hz
Heating element 2000 W
Fuse 15 A
REMO REMOVING VING THE SHIPPING THE SHIPPING
SUPPORTS SUPPORTS
The machine is transported with three shipping
supports, as illustrated below. These supports hold
the tub in place during shipment. When you unpack the
machine, you must remove these supports.
To remove these supports, follow the instructions
below:
ACCESSORIES ACCESSORIES
1. Unscrew the 5/8" (13
mm) bolts holding
the supports in place
and remove the
bolts.
2. Push the rubber
spacer up then pull it
out of the slot.
3. Rotate the spacer so that the extruded
end points toward the machine.
4. Insert it into the slot
and push down to lock
it into position.
UCTIONS
You must remove the
shipping supports
before you install the
washer.
NOTE: Cosmetic damage must be reported to your
dealer within five days from the date of
purchase. After unpacking the washer,
thoroughly check the unit for cosmetic damage.
Drum and Barrel Stainless steel
Outer casing Stove-enamelled hot-dipped
galvanized steel
Mounting Four adjustable rubber-covered
feet
Inlet supply hose 5 ft. (1.5 m) PEX tubing with
brass ferrules
Supply pressure 15–142 PSI
Outlet hose 5.5 ft. (1.7 m) polypropylene hose,
3/4" ID
ADJUSTING THE FEET ADJUSTING THE FEET
It is important that the machine is level so it won't vibrate
excessively during the spinning cycles. Each foot on
the washer is adjustable, so you can level the washer
on any surface. Once it is level, securely tighten the lock
nuts on the feet to prevent excessive vibration during
the spin cycles.
Be sure to tighten the
lock nuts securely
when you level the
machine.
WA WATER SUPPL TER SUPPLY CONNECTION Y CONNECTION
Because ASKO washers have their own heating
element, you only need to have a cold water inlet. The
connection should be made by someone who is
sufficiently skilled. Use the hose supplied with the
washer.
Water pressure must be in the range of 15–146 PSI.
A tap should be fitted on the water supply pipe.
If a new supply pipe has been installed for the washer,
it should be flushed thoroughly to remove any foreign
particles that might clog the strainer in the water inlet.
Tap
Cold water
supply
Page 15