Table of Contents
Advertisement
Battery Installation
Place the batteries in the monitor in the following order:
1
1.
3.
After battery installation, it is required to set
the year, date and time rst. A correct date
and time is very important for tracking your
blood pressure recordings. Related setting
procedures are provided in the "Setting the
Time" section on page 14.
Connecting Cu to the Unit
Insert the cu jack into the cu inlet on the left side
of the unit.
Fitting the Cu
1. Wrap the cu around a bare-skinned left
upper arm. Be sure the air tube points down in
the direction of lower arm when it comes out
of the cu .
2. Tighten the cu , but make sure it is not too
tight so that you allow proper in ation.
The cu 's lower edge should be about one
inch from the elbow.
3. If it is not possible to t the cu to the left arm,
it can also be wrapped around the right
upper arm.
The standard cu equipped with this device is a Medium size. It is
suitable for those with an arm circumference between 22cm to 32cm
(8.75 ~ 12.5 inches). Arm sizes out of this range might cause an incorrect
measurement .
2.
3
4.
BPM 1000i
Blood Pressure Monitor
2
4
9
Advertisement
Table of Contents
