D-Link DNS-313 User Manual page 29

Section 3 - Configuration
User /Group
Select the user or group the FTP server rule will apply to.
Folder
Browse to and select the folder or directory you are granting FTP access to. Select root to grant access to all volumes.
Permission
Set the user or group permission to Read Only or Read/Write.
Max User
Sets the maximum amount of users that can connect to the FTP server.
Idle Time
Sets the amount of time a user can remain idle before being disconnected.
Port
Sets the FTP port. Default is 21.
Flow Control
Allows you to limit the amount of bandwidth available for each user.
FTP Access List
Lists all defined FTP Rules.
If you are behind a router, you will need to forward the FTP port from the router to the DNS-313. Additional
filtering and firewall settings may need to be modified on your router to allow FTP access to the DNS-313
from the Internet. Once the port has been forwarded on the router, users from the Internet can access the
FTP server through the WAN IP address of the router.
If you are using a D-Link router, such as the WBR-2310 used in the example below, your port forwarding rule
should be similar to the following:
29