Connecting The Speakers; Connections When Using The Speaker Input Wire - Pioneer GM-D8500M Owner's Manual

Section
liD (
Conneding the units
)
c~
)
• Install and route the separately sold battery
wire as far as possible from the speaker wires.
Install and route the separately sold battery
wire, ground wire, speaker wires and the am-
plifier as far away as possible from the anten-
na, antenna cable and tuner.
(!J
Conneding the speakers
Connect the speaker leads to suit the mode
according to the figures shown below.
One-channel output
CD
SubwooferC!J
Connedions when using
the speaker input wire
Connect the car stereo speaker output wires
to the amplifier using the supplied speaker
input wire with RCA pin cord.
@ Black: Right
8
®
Black: Left
8
®
White: Left
~
(J) Speaker input wire with RCA pin cord
To the RCA input jack of this unit
II
Note
• If speaker wires with an RCA pin cord from a
headunit are connected to this amplifier, the
amplifier will automatically turn on when the
headunit is turned on. When the headunit is
turned off, the amplifier turns off automati-
cally. This function may not work with some
headunits. In such cases, please use a sys-
tem remote control wire (sold separately). If
multiple amplifiers are to be connected to-
gether synchronously, connect the head unit
and all amplifiers via the system remote con-
trol wire.
• Connect the system remote control wire when
you wish to only turn on the car stereo. not the
amplifier.
(!)
CD
•
CD
Car Stereo
@ Speaker output
®
Red: Right
~
CI)
En