Advertisement
English
Installation
WARNING
• Avoid installing this unit in such a location where the
operation of safety devices such as airbags is prevented by
this unit. Otherwise, there is a danger of a fatal accident.
• Fix this unit securely to the steering wheel with the belt
attached to the unit. If this unit is loose, it disturbs driving
stability, which may result in a traffic accident.
• Do not attach this unit to the outer circumference of the
steering wheel. Otherwise, it disturbs driving stability,
causing a traffic accident. Always attach this unit to the
inner circumference of the steering wheel as shown (Fig.
5).
Notes
• Do not install this unit in a place that may obstruct the
driver's view.
• Since interior layout differs depending on the type of
vehicle, the ideal installation location for the unit also
differs. When installing the unit, select a location that
assures optimum transmission of signals from the unit to
Pioneer Head Unit.
Accessories (Fig. 4)
A Remote control unit
×
B Holder
1
×
C Belt
2
D Lithium battery (CR2032, 3V)
Installing the Unit on a Left-Hand-Drive
Car
1. Hook the belt on to the holder (Fig. 6).
2. Fix the holder to the inside edge of the steering
wheel so that the holder is facing the driver
(Fig. 7).
12 Wrap the belt around the outside edge of the steering
wheel, passing the end through the slot in the holder.
3 Pull on the belt to tighten it then secure it using the
other two hooks on the holder.
4
3.
Cut off the extra portion of the belt (Fig. 8).
5 If some of the belt still protrudes, fold it back into the
slot so that it does not interfere with driving.
4. Fasten the other belt in the same way (Fig. 8).
5. Install the remote control unit in the holder
(Fig. 9).
When removing the remote control unit from the holder,
move the corrugated release section (*1) toward the
steering wheel as far as possible before sliding the remote
control unit toward you.
×
1
×
1
Specifications
General
Power source ...................... 3 V DC
Dimensions (W × H × D): .... 38 mm × 67 mm × 18 mm
Weight ................................. 37 g (including holder and
Infered Remote Control
<Wavelength> .................. 940 nm ±50 nm
<Output> .......................... typ; 14 mw/sr per infrared
Note
• Specifications and the design are subject to possible
modification without notice due to improvements.
(Lithium Battery: CR2032)
battery)
LED (2LEDs used)
Advertisement
