Winding The Bobbin - Singer HA-1 Instruction Manual

WINDING THE BOBBIN

Note: This machine uses standard
15 class bobbins. The bobbin can
also be wound while the machine
is in operation by not releasing the
stop motion knob as described be-
low, in which case, machine and
bobbin winder will operate at the
same time.
While holding the hand wheel with the left hand, turn the stop mo-
tion knob toward you. This will permit the hand wheel to turn
freely while the needle bar remains still. Place a spool of thread on
spool pin (A). Pass the thread through the tension disk (B) at right
corner of the base of the machine. Attach the thread to an empty
bobbin by winding it around numerous times or inserting it inside
out through one of the holes. Place the bobbin on spindle (C).
Push the bobbin winder (D) down until the snaps against the hand
wheel, and finger (E) drops between the sides of the bobbin. Oper-
ate the motor until the bobbin is full or the finger (E) snaps up and
disengages the bobbin winder. Do not over fill the bobbin. Cut the
thread, and tighten the stop motion screw while holding the hand
wheel. Your bobbin is now ready to be inserted in the bobbin case
(pg. 6) and installed in the machine (pg. 4).
-5-