Fitting Of Dial Pointer - Sharp QT-CD700W Service Manual

FITTING OF DIAL POINTER

Setting method of dial pointer
1) Remove the front cabinet.
2) Remove 3 pcs screws (S06) φ3 x 10 PA from tuning bracket (bottom of PWB board/pattern side), and remove 1 pc screw (S14) φ2.6 x 10 PH from
tuning bracket/CD compartment's flange (with fitting between CD compartment and tuning bracket).
3) Remove dial pointer.
4) Insert dial pointer from A direction to tuning bracket, then engages the dial pointer's guide hook into tuning control's slot properly B. (Ensure
tuning control's pin located on adjustment portion of tuning bracket.)
5) Reassemble the screws and front cabinet.
Dial Pointer
Main PWB
(S14) 1
This screw fitting between
CD compartment and
tuning bracket.
Tuning Knob
A
Tuning Bracket
Adjustment
2.6 10PH
Portion
Dial Pointer
(S06) 3
3 10PA
Main PWB
5
QT-CD700W
Pointer
B
Tuning Knob
Tuning Knob