Equipment Setup And Adjustments - Husqvarna WHF4215ETS Operator's Manual

SAFETY
TRANSPORTATION:
Turn off fuel valve and strap mower to trailer.
MAINTENANCE:
1. Keep all nuts, bolts and screws tight to keep mower in safe operating condition.
2. Engine maintenance should comply with engine manufactures specifications. See the engine
manual for specifications.
3. Never store the mower with gas in the tank inside a building where fumes can reach an open
flame or spark.
4. To reduce the risk of fire, keep the mower free of grass, leaves and excessive grease or oil.
5. Have your mower inspected and serviced each year by an authorized Husqvarna dealer.
6. Use only authentic Husqvarna replacement parts to insure the safety and quality of your
mower is maintained.
7. Safety decals should be replaced if they are missing or illegible. Decals can be purchased
from your Husqvarna dealer.
8. The hydraulic system including all hoses and fittings should be checked frequently for wear or
leaks. Never check for leaks with your hands, use a piece of cardboard or wood. Hydraulic oil
under pressure could be injected into your body and must be surgically removed within a few
hours.

EQUIPMENT SETUP AND ADJUSTMENTS

1. Uncrate mower
2. Lift up on handles until mower is level.
3. Using the hardware provided in the literature package, insert 3 bolts per side into the frame
side where the front frame connects to the rear deck. (See FIG 1) A pry bar can be used to align
the holes.
4. Line up the back edge of the front frame with the fron edge of the wheel motor mount so they
are parallel and tighten the hardware.
5. Remove the hood from the frame and install the deck belt. Be sure the belt is still wrapped
around the clutch pulley under the rear deck.(See FIG 3)
6. With the hood off, mount the muffler on the engine using the provided hardware. Reinstall
hood.
7. Cut the plastic wire ties holding the operator presence levers down.
8. Check tire pressure in all four tires. (rear tires 15 PSI, front tires 20-25 PSI)
9. Check engine oil with dipstick. Add if needed per engine manufactures specifications. (See
engine manual)
10. Check hydraulic oil level. Should be an 1.0" below the bottom of the fill tube.
11. Mount the discharge chute to the front deck using the fasteners provided on the deck.
FIGURE 1
5