Setup Menu - Sharp Aquos LC-40LE530M Operation Manual

Setup menu

Setup
Auto installation
Programme setup
Child lock
Input skip
4
Input label
Position
4
HDMI A Vi
H Child lock (TV input mode only)
Allows you to use a password to protect certain
settings from being accidentally changed.
Setting a password
1
Repeat steps 1 to 2 in Menu operation.
2
Press a / b to select "Child lock", and then
press ENTER.
3
If you already set the password, enter it here.
4
Press a / b to select "Change password", and
then press ENTER.
5
Enter the 4-digit number as a password using
0 — 9.
Change password
4
Clear password
6
Enter the same 4-digit number as in step 5 to
confi rm.
NOTE
• To view a locked channel (Lock setting in Programme
setup "Manual adjust" is set to "On"), you must enter a
password. When you select a locked channel, "Child lock
has been activated." is displayed.
• Press ENTER to display the password input window.
Clearing the password
Allow you to clear your password.
1
Repeat steps 1 to 3 in Setting a password.
2
Press a / b to select "Clear password", and
then press ENTER.
3
Press c / d to select "Yes", and then press
ENTER.
H Input skip
This setting allows you to skip the HDMI or PC input
on the input source selection operation.
HDMI 1
HDMI 2
HDMI 3
PC
Option
Enter your new password. Use 4 digits
– – – –
New password
– – – –
Reconfirm
Skip input selection of HDMI
Yes No
H Input label
You can assign each input source a label as you
prefer.
1
Press INPUT to select the desired input source.
2
Press MENU and the MENU screen displays.
3
Press c / d to select "Setup".
4
Press a / b to select "Input label", and then
press ENTER.
5
a / b / c / d
Press
new name for the input source, and then press
ENTER.
6
Repeat until the name is fully spelt out.
• The name can be 6 characters or less.
• When you want to set an input source name of less
than 6 characters, select "END", then press ENTER
to exit from the labelling menu.
NOTE
• You cannot change labels if the input source is TV.
H Position
For adjusting a picture's horizontal and vertical
position.
Selected item
H-Position Centres the image by moving it to the left
or right.
V-Position Centres the image by moving it up or
down.
H HDMI auto view (HDMI input mode only)
Selected item
Enable/ Set whether or not to use WIDE MODE
Disable based on signal recognition, including an
HDMI signal.
H WSS
WSS allows a television to switch automatically
among the different screen formats. (On, Off)
NOTE
• Try to set WIDE mode if an image does not switch to the
correct screen format. When the broadcast signal contains
no WSS information, the function will not work even if
enabled.
• Not available for COMPONENT, PC and HDMI signal.
H 4:3 mode
The WSS signal has 4:3 auto-switching that allows
you to select between Panorama and Normal.
Selected item
Panorama Wide image without side bars
Normal Normal range keeping 4:3 or 16:9 aspect
ratio
WSS signal 4:3 screen
4:3 mode "Panorama"
to select each character of the
Description
Description
Description
4:3 mode "Normal"
13