D-Link GO-RT-N300 User Manual page 34

Section 3 - Configuration
Access Control List
Click the ACL Setup button to edit the ACL (Access Control List). This takes you to the screen below.
Enable Wireless
Click to enable Wireless Access Control Mode. In this
Access Control
mode, only listed wireless devices will be allowed to
Mode:
connect to the wireless network.
Click the Apply button when you are done.
MAC Address:
Enter the MAC Address of a device you wish to allow
access for to the WLAN.
Click the Add button when you are done. This will add
the device's MAC Address to the table above.
Click the Delete button and the button in the Select field to delete the device.
D-Link GO-RT-N300 User Manual 30