Table of Contents
Advertisement
Tracking Knob
If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure for the rear tires is 15 psi (1 bar).
1.
Tracking adjustments are made using the tracking
bolt and tracking knob. The tracking bolt and
tracking knob act as limiting devices for the
motion control levers when in the full-forward
position.
2.
For preliminary tracking adjustment, move unit
to an open, unobstructed area such as an empty
parking lot or open field.
3.
Back the tracking bolt out until flush with nut.
4.
Loosen tracking knob out until flush with nut.
5.
Test operate unit by driving it at full throttle and
the full forward position on both motion control
levers. Gradually turn in the tracking bolt on the
right hand side until the unit noticeably starts
drifting right.
6.
Drive forward at full throttle with both motion
control levers in the full forward position.
Gradually turn in the tracking knob (left side) until
unit tracks straight.
Parking Brake
The parking brake is found on the left of the machine.
Pull the lever backward to activate the brake and
push forward to release it.
IMPORTANT INFORMATION
The machine must stand absolutely still when
applying the parking brake. Always set the
parking brake before dismounting. Release the
parking brake before moving the mower.
20
CONTROls
Tracking adjustment
Parking brake
8065-060
8065-006
Hide quick links:
Advertisement
Table of Contents
