Advertisement
Front Panel
2
4
AMP SELECTOR KNOB
1
Selects between the different amp settings on the Nano Vypyr. Available settings include: AGTR (Acoustic
Guitar), Clean 1, Clean 2, Overdrive 1, Overdrive 2, Crunch 1, Crunch 2, Metal 1, Metal 2, Lead 1 and Lead 2.
•
ACOUSTIC - Channel voiced for use with acoustic guitar
•
CLEAN 1 - Basic clean channel voiced for humbucking guitars
•
CLEAN 2 - Higher gain clean channel voiced for use with single coil guitars
•
OVERDRIVE 1 - A little bit of grit for that classic, overdriven, small amp tone
•
OVERDRIVE 2 - Gritty, overdriven amp tone with lots of bite
•
CRUNCH 1 - Classic rock sound...the sound of a stack
•
CRUNCH 2 - 70's arena rock rhythm tone
•
METAL 1 - Modern, chunky, high-gain tone
•
METAL 2 - Thrash metal tone
•
LEAD 1 - Lead channel with smooth, present midrange and lots of sustain
•
LEAD 2 - Lead channel with extra low end punch and slightly notched midrange. Especially good with low
output guitars.
INSTRUMENT INPUT
2
1/4" instrument input.
GAIN CONTROL
3
Controls the amount of gain. Turning clockwise will increase gain and distortion.
EFFECTS SELECTOR KNOB
4
Selects between the different effects. Available effects include: Wah (the wah becomes an auto-wah when
the optional expression pedal is not being used), Tremolo, Chorus, Compressor + Chorus, Rotary Speaker,
Phaser, Flanger and Octaver.
EFFECTS MORPH CONTROL
5
As this knob is turned clockwise, one or more effects parameters are changed. This is tuned per effect to
make effects editing as easy as possible. Note: Octaver effect is meant for single-note playing. Chords will
sound ugly if the morph knob is up. On the Comp+Chorus setting, this controls the compression level. You
can first go to the chorus and set that effect, and the Comp+Chorus will use that setting.
3
1
9
5
6
7
8
11
10
12
13
Advertisement
