Advertisement
MODELS & ACCESSORIES
This manual describes the operation and maintenance of the 6003, 6004, 6005 and 6006 King Kutter shredders.
Part Number
6003
6004
6005
6006
6011
6012
6013
6014
6015
6016
CARE AND USE
To begin using your new King Kutter shredder, follow the simple instructions listed below:
1. If Suction Cup Base: Position base assembly on work surface and push lever down to establish suction
cup firmly in place.
If Clamp Base: Affix clamp to side of table and firmly tighten.
2. Surface being used for the machine must be a non-porous type such as formica.
3. Place hopper onto the base assembly.
4. Attach cone – place center hole in cone on center pin of disk. Turn clockwise to engage disk lugs in six
holes in cone. To remove the cone, reverse procedure.
The King Kutter is a precision built, soundly engineered piece of equipment that will actually save you more than it
costs within the first year of use. The micro-keen cutting cones are nickel and chrome plated for everlasting beauty
and protection. Under normal use, your cutting cones should provide you a lifetime of trouble-free service without
dulling or rusting.
!
CAUTION:
!
CAUTION:
!
CAUTION:
On occasion, scrub the bottom of the rubber briskly with cleanser pad to eliminate any residue that has collected to
the rubber. This will help to ensure a strong seal to the non-porous countertop and reduce the risk of slipping.
King Kutter 6000 Series Ops Manual
Description
King Kutter Suction Cup Base with #1, #2, #4
King Kutter Clamp Base with #1, #2, #4
King Kutter Suction Cup Base with #1 - #5
King Kutter Clamp Base with #1 - #5
#1 Cone – Shredder
#2 Cone – String
#3 Cone – French Fry Cut
#4 Cone – Thin Slice (1/8")
#5 Cone – Krinkle Kut
#6 Cone – Thick Slice (3/16")
Do not leave cutting cones in water. It is preferable to wash cutting cones in hot water
immediately after use and leave to dry separately – or dry carefully with a soft cloth.
Do not stack cones together when wet.
Do not immerse the hopper in water as it destroys the oil in the sealed bearing.
Carefully wipe with a damp cloth to clean.
3
Advertisement
