Table of Contents
Advertisement
TO ADJUST THE SEAT (See Fig. 1)
•
Move the control levers into the neutral
position and rotate to the outside of the
machine.
•
Lift up on the back of the seat and rotate
it forward.
•
Loosen the three prong knobs on the
bottom of the seat and move the seat to
the desired position.
•
Tighten the three prong knobs and rotate
seat back to the operating position.
TO ADJUST CONTROL LEVERS
(See Fig. 2)
Sitting on the seat, in the operators position,
press both control levers forward. If both control
levers line up with each other, then no
adjustment is needed. If they do not line up,
follow instructions below.
•
Identify which control lever moves further
forward.
•
Using a 9/16" wrench, slightly loosen the
bottom hex bolt (about 1/2 turn) on the
opposite control lever.
•
Move both control levers to the front
again and apply more pressure to the
control lever that you loosened to bring
the two control levers in line with each
other.
•
Tighten hex bolts.
TO REMOVE WHEELS FOR
REPAIR
FRONT CASTER TIRES
•
Park mower on a level surface and apply
park brake.
•
Jack up the front end of the mower.
•
Using a 3/4" wrench and/or socket w/
drive ratchet, remove hex nut and hex
bolt from the caster fork.
•
Remove the tire from the fork.
SERVICE AND ADJUSTMENT
•
Remove the spacer from the inside of
the caster rim.
•
Repair tire
•
Reassemble in the reverse order of the
previous steps.
REAR TIRES
IMPORTANT:
Block front tires to prevent the
mower from rolling.
•
Park mower on a level surface and apply
park brake.
•
Jack up the rear end of the mower on the
side of the damaged tire.
•
Remove 4 lug nuts to allow wheel
removal
•
Repair tire.
•
Reassemble in reverse order of previous
steps
NOTE:
To seal tire punctures and prevent flat
tires due to slow leaks, tire sealant may be
purchased from your local parts dealer. Tire
sealer also prevents tire dry rot and corrosion.
TO START AN ENGINE WITH A
WEAK BATTERY
Lead-acid batteries generate explosive
gases. Keep sparks, flame and smoking
materials away from batteries. Always wear
eye protection when around batteries.
If you battery is too weak to start the engine, it
should be recharged. (See "BATTERY" in the
Customer Responsibilities section of this
manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT:
YOUR MOWER IS EQUIPPED
WITH A 12-VOLT NEGATIVE GROUNDED
SYSTEM. THE OTHER VEHICLE MUST ALSO
BE A 12-VOLT NEGATIVE GROUNDED
SYSTEM. DO NOT USE YOUR MOWER
BATTERY TO START OTHER VEHICLES.
27
WARNING
Hide quick links:
Advertisement
Table of Contents
