Connecting The Gps To Memory-Map On Your Pc - Memory-map Adventurer 2800 User Manual

The Picture button lets you look at pictures stored on the SD card in the Pictures folder.
The Settings button lets you change settings for the device.
Charging the device
The Adventurer 2800's battery can be charged using the included mains charger, car charger or USB
charger when connected to your PC. For the quickest charge we recommend using the mains
charger.
When not in use please make sure the battery switch is set to off to preserve the power in the
battery for when you next use the device.
Getting the most from the battery
To get the most from the battery we recommend setting the backlight timeout to either 30 seconds
or 1 minute, depending on what suits you. These options can be changed by tapping the Settings
button on the main menu when the device is turned on and then selecting Power Save and adjusting
the Backlight Off Time.
Using Memory-Map
Tap the Maps button to launch Memory-Map
Once Memory-Map has opened it will automatically begin looking for a GPS signal. Once a signal has
been acquired the GPS Lock button will become solid. Tap on this lock button and your current
location will be displayed and locked to the screen. You are now ready to go! As you move the map
will scroll underneath your position so you will always know where you are.
You can get further GPS information, such as signal strength and positional data by tapping the
Menu button, then the Settings button. On the Settings menu tap GPS and then either Satellites to
display satellite strength information, or Position to display positional information such as grid
reference, speed etc.

Connecting the GPS to Memory-Map on your PC

Unlike Pocket PCs or Garmin GPS units the Adventurer 2800 is seen by your PC as a removable drive.
This means in Memory-Map you do not connect or interact with the device using the options under
the GPS menu. Maps, routes and tracks can be sent to the device using the steps in the following
sections.
4