Pontiac G6 2008 Getting To Know Manual page 3

During a remote start, the engine will
run for about 10 minutes before turning
itself off, but can be extended 10 min-
utes by performing another remote
start sequence at any time. After two
consecutive remote starts, no additional
remote starts are allowed until the
vehicle has been started with the
ignition key.
The remote start system will not oper-
ate if the hood is open or if the key is in
the ignition.
Starting the Vehicle
To remote start the vehicle:
1. Aim the transmitter at the vehicle.
2. Press and release the
button on the transmitter.
3. Immediately press and hold the
(Remote Start) button for about two
seconds. When the vehicle starts,
the parking lamps will light and stay
on while the engine is running.
4. Repeat these steps for a 10-minute
time extension.
After a remote start, the key must be
inserted in the ignition and turned to
the Run ( ) position before driving.
Note: If the Check Engine light is illuminated
on the instrument panel cluster, the Remote
Vehicle Start System cannot be used. See
your dealer for the proper repairs.
Turning Off the Engine after
a Remote Start
If you wish to turn off the engine
instead of driving after a remote start,
perform one of the following functions:
• Press and hold the
Start) button until the parking lamps
turn off.
• Press and release the Hazard
Warning Flashers button inside the
vehicle. Press the button again to
turn off the flashers.
• Turn the key in the ignition switch
to the Run ( ) position and then to
the Off (
• The engine will automatically stop
when time expires.
(Lock)
Note: Instructions for Remote Start are pro-
vided on a tag that can be attached to your
vehicle's key chain.
See Section 2 of your Owner Manual.
REMOTE KEYLESS ENTRY SYSTEM
) position.
(Remote
3