Control Panels - GE JKP76GP Use & Care Manual

Care and Cleating of Your CooHng Center
See Cleaning Guide.
Proper care and cleaning are
important for your cooking
center to give you efficient and
satisfactory service. Follow these
directions carefully in caring for
it to help assure safe and proper
maintenance.
BE SURE ELECTRICAL
POWER IS OFF BEFORE
CLEANING ANY PART OF
YOUR COOKING CENTER.

Control Panels

Don't use sharp-edged utensils
around the control panels; the
panels may get damaged.
Clean the panels with a lightly
dampened cloth. DO NOT USE
cleaning sprays, large amounts of
soap and water, or abrasive
cleaning pads or powders. These
can cause problems with the
control mechanisms.
Temperature Probe
The probe is sturdy, but care
should be taken in handling it. Do
not twist it and avoid dropping it.
Clean as soon as possible after use.
Wipe it with a sudsy cloth, then
rub metal parts with a plastic
scouring pad, if necessary. Rinse
and dry. (You may also wash the
probe in an automatic dishwasher.)
48
Microwave Oven
Oven Lamp
To replace microwave oven lamp,
first disconnect power at main
fuse or circuit breaker panel.
Step 1: Remove grill above
microwave oven. To do so, open
microwave oven door, then remove
the two screws from the bottom
of the grill.
,
Step 2: Remove the light cover by
removing the two screws.
Step 3: Remove the tape around
the base of the light. The tape is
there to prevent the light from
loosening during shipment and
door closings. Removing the tape
might be difficult.
Step 4: Unscrew the bulb
carefully. Use a cloth to protect
your hands in case the glass
breaks.
Note: The light is not standard.
Replace it with a similar 125-volt,
20-watt bulb, which is available
from your GE supplier.
Step 5: Screw replacement bulb
into socket and replace light cover
and grill. Reconnect power to
cooking center.